Hi guys:
I am trying to setup IP address for some point IO system with adapter model 1734-AENTR.
I connect the laptop with adapter directly. Set the thumbwheel to 999. Then start BOOTP/DHCP utility. I can then see the response from the adapter. I then double click and assign the IP to it. Then when I want to assign this configuration to the device by disable BOOTP/DHCP. BUT, when I click the button, I get a Communication Error message, saying "Failed to complete the requested operation..." See my attachment.
My laptop is window 7, and I have disabled the firewall.
Another strange thing is the adapter always has a flashing red light on Module Status LED. Not sure how to clear it and if it is related with the problem above.
Any idea?
I am trying to setup IP address for some point IO system with adapter model 1734-AENTR.
I connect the laptop with adapter directly. Set the thumbwheel to 999. Then start BOOTP/DHCP utility. I can then see the response from the adapter. I then double click and assign the IP to it. Then when I want to assign this configuration to the device by disable BOOTP/DHCP. BUT, when I click the button, I get a Communication Error message, saying "Failed to complete the requested operation..." See my attachment.
My laptop is window 7, and I have disabled the firewall.
Another strange thing is the adapter always has a flashing red light on Module Status LED. Not sure how to clear it and if it is related with the problem above.
Any idea?