PROFIdrive profile sequence

Michal_dk

Member
M
Join Date
Oct 2007
Location
Vejen
Posts
153
Hi!

I'm trying to figure out what sequence to set and reset the 3 first bit in the PROFIdrive control word. I seem to remember that it is not just a question af setting one after the other, does anyone here have experience with this?
 

Similar Topics

A
Profidrive position monitoring
Hi everyone using the profidrive in s7-1200 motion control under position monitoring :the tolerance time is the amount of time that the axis...
Replies
0
Views
530
adam_lhadi
A
A
motion control with profidrive
HI using a G120 sinamics i used the Profidrive in order to control the position in the picture i showed how my system is ,alos how i set the...
Replies
12
Views
1,066
mk42
M
J
Profidrive Alarm Word
Hi all, I have a Danfoss FC302 to a S7-1500 via ProfiNet and would like to read the alarm word from the drive using telegram PP04 into PCD[3]. The...
Replies
1
Views
1,561
Michal_dk
M
V
ADD ON PROFILE OF MAXCESS CARD 29DLCANETSLIM1
MAXCESS 29DLCANETSLIM1 ADD ON PROFILE
Replies
0
Views
60
VVB_PLC
V
R
Recording a Servo Axis Move Profile
I have to rollout a common CLX PLC program to a dozen or more installations, but each installation uses a different HMI front end. Some WW, some...
Replies
8
Views
878
robertmee
R
Back
Top Bottom