MASR or MAFR

Tweeker

Lifetime Supporting Member
Tweeker
Join Date
Nov 2007
Location
Smalltown
Posts
79
In ControlLogix motion, when would you use MASR instead of MAFR? Say from a power up or an alarm condition.
 

Similar Topics

B
Which order should I use? MASD, MAFR and MASR
Let's say I have a physical axis fault, such as the axis went out of its hardware limit. Which order should I reset it? My current setup is...
Replies
4
Views
1,917
chopin
C
L
MASR not clearing motion axis fault state
One of my coworkers just shot this question my way, and I have limited (basically no) experience with servo control. The operators are complaining...
Replies
8
Views
5,021
Ken Roach
Ken Roach
Back
Top Bottom