Servomatic feed issue

loundeb2

Member
L
Join Date
Jul 2010
Location
ny
Posts
111
Hi,
I have a Servomatic III feed that just started having an issue. After the feed sensor is made, the servo feeds, stops, then jolts slightly more. This happens with each feed signal. Any ideas why this would suddenly start happening? Any resolutions?

Thank You,
Lou
 

Similar Topics

J
OT- Equipment feed
We have a new line being added in one of our facilities. In our switch gear, we have a spare 400A breaker which we were going to use to feed power...
Replies
4
Views
2,132
mylespetro
mylespetro
P
ASCii Line Feed Data
Hello all, as you probably are all aware I have been trying to interface an A&D GX4002A balance to a 1769-L24ER-QBFC1B controller by the use of a...
Replies
7
Views
1,471
PLChristian
P
P
ASCii Line Feed Data
I am using an AB1769-ASCII card and a 1796-L24ER controller to read data from a scale. The data I am currently receiving is all Line Feed data...
Replies
7
Views
2,552
PLChristian
P
D
Gravimetric Feed
Hi everyone. Here is the question! How a PID works on a Loss in Weight feeder? Gravimetric feed and Volumetric feed as well. What calculations...
Replies
3
Views
2,268
drbitboy
drbitboy
Z
Metric conversion, With Standard feed through
This site has helped me many a time so I wanted to give back with something I worked on recently. I needed to set up a PV HMI in FTME that was...
Replies
0
Views
1,415
zavia
Z
Back
Top Bottom