Hi, guys, how r u?
We have a small project to control a blade up and down. After the configuration on 1768-L43, we downloaded the program and DIs and DOs are functional.
We plan to use an encoder (part number: 15S-20M8-0360NV1R3PP-J00-S1) to monitor the height of the blade, so we connected it to 1769-IF8 module.
But no matter how to rotate it, this is no value change on 1769-IF8 channels.
Could somebody tell us how to figure it out?
Thanks a lot.
We have a small project to control a blade up and down. After the configuration on 1768-L43, we downloaded the program and DIs and DOs are functional.
We plan to use an encoder (part number: 15S-20M8-0360NV1R3PP-J00-S1) to monitor the height of the blade, so we connected it to 1769-IF8 module.
But no matter how to rotate it, this is no value change on 1769-IF8 channels.
Could somebody tell us how to figure it out?
Thanks a lot.