faisal rasool
Member
what is a floating point in s7 and how we use it.
what is floating point in S7
- Thread starter faisal rasool
- Start date
http://www.plctalk.net/qanda/showthread.php?t=13869
The above thread should help you out.
http://www.plcdev.com/step_7_elementary_data_types
Regards,
Garry
http://www.accautomation.ca
The above thread should help you out.
http://www.plcdev.com/step_7_elementary_data_types
Regards,
Garry
http://www.accautomation.ca
faisal rasool
Member
OP
Thanks gclshortt
Similar Topics
I need to check an axis actual travel position, and to compare it to the master travel position.
To do this I have to multiply the axis travel...
We have AOIs for projects, which handle material dosing (by hand or by pipes and pumps), obviously they have comparison between setpoint and...
Hi eveyone. I need transfer signal from system 1 to DCS via modbus. System 1 only can send 32 bit floating point. DCS receive 16 bit integer. How...
Hi, In my ladder logic, I've got a data register D60 whose value is -0.001 (when using monitor mode to see values). D406 is 0.250.
But then...
Hi,
can anybody tell that how can we move floating point data from one Regiter to another register in Fatek PLC.?