E300 Beijer Run Mode

mayorx

Member

M

Join Date

Oct 2015

Location

Szczecin

Posts

2

• Oct 28, 2015

• #1

HMI Can't start to RUN mode.
- - HMI after RS422 Chip replace - -
Question- what I should to do to go to RUN MODE

Cable - original after
Ports - RS422 tested in E-Designer, possible to download the softfrom HMI
Communication settings
a) Port Parameters : RS422, 9600, 81EVEN


First communicat after start

After ENTER

After a few minutes

PLC

 

gclshortt

Member

Join Date

Dec 2014

Location

Ontario

Posts

3,217

• Oct 28, 2015

• #2

This thread may help you out.
http://www.plctalk.net/qanda/archive/index.php/t-64954.html

Regards,

 

BryanG

Member

B

Join Date

Feb 2005

Location

Manchester

Posts

1,985

• Oct 28, 2015

• #3

I would probably try to re-flash the firmware. PM me if you don't have the firmware available.

 

mayorx

Member

OP

M

Join Date

Oct 2015

Location

Szczecin

Posts

2

• Nov 2, 2015

• #4

Problem solved:
1) I have set bellow settings and panel E300 start in RUN mode

Thans gentelmens for support.

 

jakaniteam

Member

J

Join Date

Jan 2016

Location

266

Posts

1

• Jan 29, 2016

• #5

E300 beijer

I HAVE BEIJER PANEL INSTALL IT IN BOAT ,
when i switch it on i see in screen


E300 SYSTEM ERROR CFA#1

please whats the problem


need help

thank

need to reflash firmware or what ?

 

BryanG

Member

B

Join Date

Feb 2005

Location

Manchester

Posts

1,985

• Jan 30, 2016

• #6

Haven't ever seen a System Error like that so can't advise. Have a look at the attached file, it shows you how to get the system to run a self test, maybe that will give more info on the problem. Otherwise re-loading the firmware shouldn't do any harm.