SLC 100 with handheld programmer

dsantiago

Member
D
Join Date
Nov 2015
Location
Virginia Beach
Posts
1
Hi I am new to plc's I want to program a 3 story elevator with it and want to use a 12v dc battery the specs on the motor for current is load current .91A max 1.37A, and no-load current .34A. This motor is bidirectional DC motor. Can I use the plc for this motor?
 

Similar Topics

P
SLC 100 expansion module replacement
Hi everyone, I have a broken SLC 100 expansion module that I need to replace my question is do I have to do any programming to achieve this? from...
Replies
2
Views
1,571
rupej
R
K
Router's orange 10/100 light not on, with SLC 5/05
More of a "Is this normal" question. I was troubleshooting why I couldn't ping an SLC from my desk. I have a Spider 5TX between my 5/05 and a...
Replies
5
Views
1,721
PLCnovice61
P
I
micrologix_1100.rss project to .slc
Hi there, as the title suggest I was hoping that someone could help me out a little bit. I am currently updating an pallet trolley system from...
Replies
2
Views
1,312
illibilli
I
A
UDS1100 to SLC 5/04
Hello Friends I have gotten a UDS1100 to connect a 5/04 PLC to Ethernet through serial port. I have set the IP address in the UDS1100, but I can...
Replies
4
Views
2,166
Ken Roach
Ken Roach
A
Communication SLC 5/04 to ML1100
Hello Friends I need to share some bits and integers between SLC 5/04 and a ML1100. I am thinking in Lantronix UDS1100 connected to a switch...
Replies
1
Views
2,126
OkiePC
OkiePC
Back
Top Bottom