E300 overload replay IO configuration

minaykha

Member
M
Join Date
Apr 2009
Location
singapore
Posts
96
Hi ,

I am looking for the solution, how to configure I/O of E300 . For example , Input 1 trigger Output 1, Input 2 trigger Output 2.

In E3plus , I can configure it by using Rsnetworx and Devicelogix function block.

But, in E300, I cannot do it in Devicelogix setup. ( please look into attachment picture ).

Please advise , thank.


devicelgx E300.jpg
 

Similar Topics

A
E300 Overload Relay Emulation Mode Hardware Fault
Hi, I'm using E300 as E3 Plus in emulation mode. E300 is Rockwell Automation's overload relay. But I get hardware fault when I enable Ground...
Replies
0
Views
462
Asefakaratas
A
P
AB- E300 Overload Relay Firmware Flash
Hi everyone, I have So many E300 Control module kept dead due to Module status fault. I am trying to flash them to higher version from lower...
Replies
0
Views
394
prakasha
P
M
E300 overload relay
I'm working on a E300 overload relay and I'm trying to figure out where I can find information on the communications. I'm using a preconfigured...
Replies
7
Views
2,008
alan_505
A
R
193-E300 overload relay - experience?
Hi, I'm currently trying to understand this product. A customer has asked if we can incoorporate it in a system he will be offered. The system...
Replies
4
Views
3,784
smiller
S
P
Connection error with E300 overload relays (Ethernet)
This is my first time using these E300 overloads in an application. I used "Discover Modules" to add them so that they would be added just as...
Replies
11
Views
5,491
Keystone
K
Back
Top Bottom