Proface to Toyopuc question

First post but need some advice about using a Proface screen connected to 3 Toyopuc PC3J's. All plcs have FL net/ethernet cards and are connected to a hub. i have connected a laptop to the hub and can ping each plc via ethernet. Question i have is how do i setup the addressing to communicate with the Proface ? I only want to use the Proface as a status screen , no commands to be sent to the Plcs just want to monitor inputs and outputs etc

any help much appreciated

Daz

https://www.kepware.com/products/kepserverex/drivers/toyopuc-pc3-pc2-ethernet/documents/toyopuc-pc3-pc2-ethernet-manual/

I would start with Device Setup from the Toyopuc PC3/PC2 Ethernet Driver manual above.

Now you can refer to the Proface device communication manual:
http://www.pro-face.com/otasuke/files/manual/gpproex/new/device/toy.htm

Regards,

Garry
Many thanks for your reply , that's exactly what I'm looking for. Will print out in work tomorrow and give it a go. Will let you know how I get on. Once again many thanks
Daz.

still having a few problems setting up , one thing is confusing me though. proface show connecting all 3 plcs via FL net to a hub then ethernet from hub to screen. whats the difference between FL net and ethernet ?