1746-no4v analog configuration

Hello, I am trying to configure the channels on a 1746-no4v card. I just did a 1746 ni8 using the Adv Config button. RSlogix threw in a rung of logic with a status bit and a COP instruction.

My attempts to do the same with the 1746-no4v have failed. This is a class 1 card.

Manual isn't helping.

Help!

There is nothing to configure for a 1746-NO4V. The output range depends on the data values you write to the modules output image word, see manual below.

There is a switch for selecting external or backplane power. See pdf.


https://www.google.com/url?sa=t&rct...cet7mN4AXTLnYJiB6tgzjw&bvm=bv.107763241,d.cGc

controls engineer

You're right. I found out the hard way.... on my own. Manual makes it look like you have to configure it. So does RSLogix.

Thanks anyway. I will have more questions in the future I'm sure.