Master logic 200R PLC and scada system hardware

shkoko2000

Member
S
Join Date
May 2011
Location
cairo
Posts
296
dear all,
i will perform fat test on Master logic 200R PLC and scada system hardware,can anyone help me to do this procedures in correct manner?and what are the important points that i concentrate on them?
what is meant by plc based on fault tolerant ch/rs?
 

Similar Topics

E
logic master 5
Anyone has the software for GE Fanuc Logicmaster Series 5, having ahard time finding it
Replies
10
Views
2,539
Lalo Pacheco
L
G
[HELP]ABB watermaster wiring and ladder logic to GE PacSys RX3i95
Good morning folks, I need your help and I am a beginner on PLC and I have been given an assignment on wiring a flowmeter to plc and create a...
Replies
3
Views
2,217
grinerjowker
G
J
Machine sequence logic, multiple instances vs one master
So, i have a machine that I'm programming say the sequence is 1-2-3-4-5. If the operator hits the 'start' button it will step through the...
2
Replies
18
Views
3,489
James Mcquade
J
J
Logic Master 90 programming
Hi All, it's been 8 yrs since i last do a PLC job and now i totally forget how to use the logicmaster software :mddr: . i have a GE Fanuc Series...
Replies
10
Views
4,276
Steve Bailey
Steve Bailey
A
GE Logic Master 5
Hi, I have an old Series 5 PLC which lost its software. I have full printout of Ladder Diagram but did not found the Software that will help...
Replies
7
Views
2,738
aganim
A
Back
Top Bottom