S71200 pto amplitude
- Thread starter crb_n
- Start date
If you use the built in outputs, 24V.
If you want 5V, there is a signal board that can be purchased.
Similar Topics
Hi Folks. Has anyone used an SEW EI7C encoder with an S71200 PLC? If yes, how is it done? I use this same encoder in EI76 mode with a...
Hi everyone
I am completely new to using shift registers and am a bit stuck, my shift register works as should, it is for an overhead conveyor...
Dear Experts,
Warm Greetings !
By using TCON,TSEND,TRCV,TDISCON block,I am trying to make communication with my...
Hello;
i'm having some troubles with a com test i'm handling.
i have another end for it, but for now i would like to have :
M241 in io_scanning...
I got Meinberg as NTP server, and it is in same network as My S71200 PLC.
I went (Device configuration -> Ethernet Port ->time synchronization)...