ICS Triplex AAdvance PLC (9000 SERIES) DDE Communication with KEPserver5
- Thread starter MERAJMJ
- Start date
AADvance Controller:
http://literature.rockwellautomation.com/idc/groups/literature/documents/rm/icstt-rm448_-en-p.pdf
Kepware Server:
https://www.kepware.com/products/kepserverex/documents/kepserverex-manual/
Search for ... "How To... Use DDE with the Server"
KEPServerEX, DDE, and Excel
https://www.kepware.com/support/resource-library/connectivity-guides/kepserverex-dde-and-excel.pdf
You did not indicate how you were communicating. Modbus would work for this equipment. The above links should help you out.
Regards,
http://literature.rockwellautomation.com/idc/groups/literature/documents/rm/icstt-rm448_-en-p.pdf
Kepware Server:
https://www.kepware.com/products/kepserverex/documents/kepserverex-manual/
Search for ... "How To... Use DDE with the Server"
KEPServerEX, DDE, and Excel
https://www.kepware.com/support/resource-library/connectivity-guides/kepserverex-dde-and-excel.pdf
You did not indicate how you were communicating. Modbus would work for this equipment. The above links should help you out.
Regards,
Similar Topics
Hi,
The 24 volts power supply module to my ICS triplex test kit went bad causing power outage to the kit. When the power was replaced the...
Hi, every body,
i need your help about a little problem concerning a blocked analog variable in the same value despite of modification requests...
After some interesting conversation regarding the safety of emergency stops, I saw some posts talking about the safety standard conversation...
Does anyone happen to know how to install the graphic picture in HMI when I go into blower selection there are no graphics shown not only blower...
Does anyone happen to know how to install the graphic picture in HMI when I go into blower selection there are no graphics show not only blower...