Mvi56-egd
- Thread starter grider75
- Start date
Steve Bailey
Lifetime Supporting Member + Moderator
It's not Modbus.
EGD is proprietary to GE. Rather than the Modbus command/response exchange, EGD uses a producer/consumer model. Once an exchange is configured, the producer will refresh the data at the rate determined by the configuration without the consumer having to issue any more commands.
EGD is proprietary to GE. Rather than the Modbus command/response exchange, EGD uses a producer/consumer model. Once an exchange is configured, the producer will refresh the data at the rate determined by the configuration without the consumer having to issue any more commands.
For details: MVI56 EGD User Manual - ProSoft Technology
Similar Topics
Hello, I have an MVI56-MNET module, which is installed together with EN2TR, with a subnet of ~10, all instructions have been added to the project...
can we use Allen-Bradley 1756-L55 controller to communicate with MVI56-MCM Modbus communication module
Hi everyone,
Has anyone on the Forum used the Prosoft Flow Computer before? What was your opinion of it? I am quoting a well pad job and was...
I am very new when it comes to programming thing using a Prosoft card using Modbus. I am fine to figure that out by studying the manual. However I...
Hi all, this is the first time I have posted on here, I have been reading with interest for a few years now.
The problem I have is regarding...