martinshaw
Member
Hi
Working with some project guys who have replaced a controllogix processor previously using RSLogix 5000 V11 for a controllogix 5588E using Studio 5000 Logix Designer, V32. The IP address of the PLC has remained the same as has all the module slot positions.
The problem I have is with a legacy machine using XP that cannot now connect to the new processor using Kepware. I am almost certain that its a version conflict now between Kepware and the new processor. The version of Kepware is V4.0. I have also tried Kepware V6 and this kind of works intermittently, but not satisfactory.
Question is, anybody know what version of Kepware I need to use to communicate to a Controllogix processor programmed with Studio 5000 V32?
Thanks in advance
Martin
Working with some project guys who have replaced a controllogix processor previously using RSLogix 5000 V11 for a controllogix 5588E using Studio 5000 Logix Designer, V32. The IP address of the PLC has remained the same as has all the module slot positions.
The problem I have is with a legacy machine using XP that cannot now connect to the new processor using Kepware. I am almost certain that its a version conflict now between Kepware and the new processor. The version of Kepware is V4.0. I have also tried Kepware V6 and this kind of works intermittently, but not satisfactory.
Question is, anybody know what version of Kepware I need to use to communicate to a Controllogix processor programmed with Studio 5000 V32?
Thanks in advance
Martin
Last edited: