dalem
Member
Good afternoon folks.
I know you all like digging way back into your memory banks, so here goes.
We have an old machine with a Creonics/SAM-EX MCC board in it. The main board (bottom one) in this stack has a problem and I'm trying to get the application out of this board to put in a new board I just purchased. I can connect to this and go to terminal mode and check a series of parameters but when I try to retrieve the whole application or parts of it with Access, I get a timeout error which also states no response from the MCC.
Anyone have any clues as to why I can not retrieve the application or control blocks from this board? Any suggestions for other things I can try? This is a spare board we have on hand but I need to have it operable. THe machine is scheduled to retire this year or soon there after, so an upgrade is out. For now, I just need to have a useable spare.
Thanks,
Dale
I know you all like digging way back into your memory banks, so here goes.
We have an old machine with a Creonics/SAM-EX MCC board in it. The main board (bottom one) in this stack has a problem and I'm trying to get the application out of this board to put in a new board I just purchased. I can connect to this and go to terminal mode and check a series of parameters but when I try to retrieve the whole application or parts of it with Access, I get a timeout error which also states no response from the MCC.
Anyone have any clues as to why I can not retrieve the application or control blocks from this board? Any suggestions for other things I can try? This is a spare board we have on hand but I need to have it operable. THe machine is scheduled to retire this year or soon there after, so an upgrade is out. For now, I just need to have a useable spare.
Thanks,
Dale