Reversible counter

95ee32069

Member
Join Date
Jun 2005
Posts
5
Hello
I am using the reversible counter to do a design using the omron CPM1A and would like to know the address of its command flag? Also does anyone know the address of different flags for the various instructions of the CPM1A?
 

Similar Topics

Anyone has a suggestion for a 3 phase solid state relay that is reversible? I've seen them used to change the direction of motors. However I don't...
Replies
5
Views
2,910
Hey Everyone, After reading a lot on this forum and elsewhere I see not many are fond of the 1794-VHSC module. I can see to a degree as I was...
Replies
2
Views
32
Hello Folks, Has anyone configured a Momentum high speed counter on Unity 13.1. We need the wiring diagram for Momentum High speed counter and...
Replies
0
Views
65
Hi all, I am working with an incremental encoder (ABZ signals, 360 ppr (so 1440 counts per rev)) to replace the existing "manual" encoder wheel I...
Replies
25
Views
806
Hi y'all Just a quick question for using Rslogix 5000 I'm using a counter up bit with an analog signal (0-10V). When 10V is measured, counter...
Replies
5
Views
204
Back
Top Bottom