I am trying to reset a fault through programming. I have a Micrologix 1200 and I am programming through RS Logix 500. I have been combing through the help files and been serching though posts here and have so far not found anything specific enough to really help me out. There are references to resetting the S:1/15 bit. However, I have not found a way to actually do this. I have tried a rung with a OTU and a RES, neither work. I tried both a MOV and MVM, however I get an error that says that I can not set that to the word level.
I also would like to set the bit S:1/9 to automatically clear faults on startup but when I add a rung with that bit as a cail, I also end up with an error. I figured there is maybe a check box somewhere to turn that on that I do not know about?
There is also reference to a "user fault routine" that runs when there is a fault. How do I go about setting one of those up?
Thanks everyone!
Greg
I also would like to set the bit S:1/9 to automatically clear faults on startup but when I add a rung with that bit as a cail, I also end up with an error. I figured there is maybe a check box somewhere to turn that on that I do not know about?
There is also reference to a "user fault routine" that runs when there is a fault. How do I go about setting one of those up?
Thanks everyone!
Greg