djhowelle
Member
good day to all,
I'm currently working on a project using master-k K3P-07AS plc and I'm having problem communicating my pc to the plc.
I already followed the instruction manual for communication setting but still I cannot communicate to the PLC.
I'm using a serial to Usb converter, is there any exact configuration in my device setting like baud rate,stop bit, etc.?
I also check my rs-232c cable wiring and it is correct. 2-3, 3-2, 5-5 as follows.
hoping for a kind resposne.
thank you and more power...
I'm currently working on a project using master-k K3P-07AS plc and I'm having problem communicating my pc to the plc.
I already followed the instruction manual for communication setting but still I cannot communicate to the PLC.
I'm using a serial to Usb converter, is there any exact configuration in my device setting like baud rate,stop bit, etc.?
I also check my rs-232c cable wiring and it is correct. 2-3, 3-2, 5-5 as follows.
hoping for a kind resposne.
thank you and more power...