V-Memory Locations (DirectSoft)

This particular set of instructions seem to be the setup memory locations for high speed counting. The manual for the particular CPU - or for a add on CTRINT card will give you the meaning of the particular K values going to each of the V memory locations.
 

Similar Topics

Hi again all, wondering if someone can help me. I have a programming running on an M221 PLC and I want to capture some analog data to a series of...
Replies
6
Views
6,202
I have a Direct Logic DL05 (DO-05DR) PLC I'm using with a samkoon touchscreen. I've got communication going between the two using Modbus, but...
Replies
25
Views
7,435
I have six single memory locations receiving the number of hours that six pumps have been ran for. I need to know which of these pumps hast the...
Replies
2
Views
1,885
Hello all, Some of you might remember a few weeks ago I was working on adding a bar code reader to a DL06. After some time and help from this...
Replies
1
Views
1,710
I have a c-more micro with a three digit input box on one of the screens. This is being written to a memory location in a DL05. I don't have the...
Replies
3
Views
85
Back
Top Bottom