gbradley
Lifetime Supporting Member
I want to turn on a bit in my PLC, and when I do that have the HMI go from any page to Page 1.
Page 1 is my start up page.
I want to make it so that if the stop button is pressed, the cycle stops, and the HMI switches to the start page.
Here is what I tried that didn’t work for me:
I created a Flagtag called “GoToPage1” Source B9[32]
In Data Actions; On Write: General GotoPage(Page1)
When I turn the B9[32] bit on, I can see my indicator for the Flag turn ON, but the HMI doesn’t turn the page.
I used my Tag as the action in a button, and that works fine, if I push the button, It goes to Page1.
If I remotely change the value of the bit, the button indicator gets highlighted, but the screen doesn't change.
Thanks for any and all suggestions.
G304K >>> 1769L30ERM Crimson 3.0 Native tags via L5K Ver 1.04
Page 1 is my start up page.
I want to make it so that if the stop button is pressed, the cycle stops, and the HMI switches to the start page.
Here is what I tried that didn’t work for me:
I created a Flagtag called “GoToPage1” Source B9[32]
In Data Actions; On Write: General GotoPage(Page1)
When I turn the B9[32] bit on, I can see my indicator for the Flag turn ON, but the HMI doesn’t turn the page.
I used my Tag as the action in a button, and that works fine, if I push the button, It goes to Page1.
If I remotely change the value of the bit, the button indicator gets highlighted, but the screen doesn't change.
Thanks for any and all suggestions.
G304K >>> 1769L30ERM Crimson 3.0 Native tags via L5K Ver 1.04