PLCS.net - Interactive Q & A

PLCS.net - Interactive Q & A (http://www.plctalk.net/qanda/index.php)
-   LIVE PLC Questions And Answers (http://www.plctalk.net/qanda/forumdisplay.php?f=2)
-   -   Connected Components Workbench Analog Output Programming (http://www.plctalk.net/qanda/showthread.php?t=113266)

grant.dotulong December 7th, 2017 09:41 AM

Connected Components Workbench Analog Output Programming
 
Hi all,

I'm having trouble programming the analog output on my Allen Bradley Micro850 with OF4 extension. I enabled the channels, minimum-maximum output range 4-20mA, with the data format in engineering units. I'm trying to control an inverter wired to a motor. I used the MOV instruction block to assign my analog output with values from my analog inputs, but it seems that the analog output does not produce any signals (tried with my multimeter) even though there are values in CCW's live mode. Does anyone have the solution for this?

Thanks,

-Grant

gclshortt December 7th, 2017 02:05 PM

http://www.plctalk.net/qanda/showthread.php?t=103739

http://www.plctalk.net/qanda/showthread.php?t=92574

Here are a couple of threads that may help you out.
Regards,


All times are GMT -5. The time now is 06:01 AM.

.