Thread: PowerFlex 700
View Single Post
Old December 7th, 2017, 04:14 PM   #7
qsubhani
Member
Canada

qsubhani is offline
 
Join Date: Jan 2014
Location: Markham
Posts: 13
I am a bit confused that when my motor runs on network through DPI port 5 where it gets the speed signal.
My understanding that when runs on DPI port 5 (Parameter# 93 = 22)motor gets the control command and goes to Preset speed 1 selection and if I need to control from terminal blocks than I need preset speed selection 1 to 7(parameter#101 to 107)
  Reply With Quote