Hello Everyone,
I am trying to communicate to HMS Anybus gateway module 7072-B, via RSLogix 5000 V20. I have followed application note 'Anybus Communicator EtherNet/IP with Rockwell Studio 5000', located here:
https://www.anybus.com/support/file-doc-downloads/communicator-specific/?orderCode=Ab7072
When I add the module (using the eds file) and try to change the IO data size in module definition, i am not able to save the configuration changes by clicking on the okay button which appears to do nothing. Therefore I can not modify the default settings which are: SINT, 16 bits input and 16 bits output.
Has anyone come across this before or a similar situation?
I've also tried to set the anybus up as generic ethernet module but am receiving comms faults when I do this. The application note mentions that RSLogix 5000 V20 should use the .eds file.
Thanks in advance,
Brett
I am trying to communicate to HMS Anybus gateway module 7072-B, via RSLogix 5000 V20. I have followed application note 'Anybus Communicator EtherNet/IP with Rockwell Studio 5000', located here:
https://www.anybus.com/support/file-doc-downloads/communicator-specific/?orderCode=Ab7072
When I add the module (using the eds file) and try to change the IO data size in module definition, i am not able to save the configuration changes by clicking on the okay button which appears to do nothing. Therefore I can not modify the default settings which are: SINT, 16 bits input and 16 bits output.
Has anyone come across this before or a similar situation?
I've also tried to set the anybus up as generic ethernet module but am receiving comms faults when I do this. The application note mentions that RSLogix 5000 V20 should use the .eds file.
Thanks in advance,
Brett