View Single Post
Old October 27th, 2021, 11:08 AM   #5
Mas01
Member
United Kingdom

Mas01 is offline
 
Join Date: Oct 2020
Location: Leicester, England
Posts: 559
Quote:
Originally Posted by parky View Post
Although those are intelligent modules according to the manual they are 16 point so there should be no problem, I believe it will not matter if you leave it at 32, it may be possible to change it to 16, however, not having some intelligent modules to test it I cannot assure you that it would not change the rest of the I/O I do not believe it will, just leave a gap of 16 I/O points I suggest you document the current addresses, change it then see if the rest stay as they are configured, you can always go back.
Thanks, yes, I will definitely record the current settings in case I need to go back. Good idea.

Just for info, There is a message on the screen in the picture "Assigning the IO address is not necessary as the CPU does it automatically. Leaving this setting blank will not cause an error to occur".

Last edited by Mas01; October 27th, 2021 at 11:36 AM.
  Reply With Quote