PWS3261/HMI/HItech

msalman

Member
M
Join Date
Mar 2018
Location
ibd
Posts
4
help required to download program PWS3261 HMI and connect with RS232C port of PLC,
cheksum error in start(firmware problem?),
without removing checksum error ,making single button and compiling program then only application download working but no display on hmi on run,
download firmware and application not working shows timeout error
dip switches, 5 and 6 off only other all on
please help
 

Similar Topics

R
HiTech PWS3261 HMI
I am not familiar with Hitech HMI. I had to replace a defective screen with a new one. Screen was not readable on the old one and it displayed...
Replies
2
Views
3,294
andybutcher
A
S
Rockwell hmi coms issues
Hi I have a couple of hmi panel view plus 700 Hmi and we keep dropping coms /stars in the data boxes I’ve checked the plc and unmanaged switch...
Replies
6
Views
140
Operaghost
Operaghost
I
Make an HMI convert from inches to PUUs (numeric input) before writing to servo drive
Hello all, I'm currently working on a servo motor linear positioning system (ball screw). I'm all set up regarding communication between my HMI...
Replies
1
Views
79
parky
P
N
FactoryTalk View ME - Visibility Based on HMI's IP Address
Hi, I wanted to ask is there a way to have a visibility expression use the IP address of the HMI (Dynics, not PV) to show certain elements? The...
Replies
3
Views
160
nievesdelimon
N
B
20-HMI-A3
how do I connect the 20-HMI-A3 to the powerflex 525
Replies
2
Views
102
bdee
B
Back
Top Bottom