Hello All,
I have two questions.
1- I am using two msg instructions in plc2 to read two different msgs from other plc1 so i was wondering that if it is possible to use a 1 msg instruction or any other simpler way.
2- it is very silly but since i am new to this so question is i have a rung say rung 2 that will activate only when a condition at later rung say rung 7 goes true, when rung 7 goes true it does wait for next scan rung 2 goes true at the same time what i can do about that.
I am using AB ML 1400, Rslogix500
I have two questions.
1- I am using two msg instructions in plc2 to read two different msgs from other plc1 so i was wondering that if it is possible to use a 1 msg instruction or any other simpler way.
2- it is very silly but since i am new to this so question is i have a rung say rung 2 that will activate only when a condition at later rung say rung 7 goes true, when rung 7 goes true it does wait for next scan rung 2 goes true at the same time what i can do about that.
I am using AB ML 1400, Rslogix500