Demontager
Member
I got a question regarding Fx3U-64M and Fx2N-64MR PLCs controllers.
The situation is as followed:
I'm working at ship and it has Bow Thruster and Stern Thruster and these thrusters have above mentioned PLCs. Once old one PLC Fx2N-64MR was damaged by salt water and it was on Bow Thruster.
Without a spare PLC i just removed working PLC from Stern Thruster and installed it to Bow Thruster.
Then my company sent a new PLC as they said new model- Fx3U-64, and I have installed it to Stern Thruster, but the problem is - I don't have a logic algorithm for Fx3U-64, EEPROM is new and without any logic, so i need to program it. But working logic still exists in old module Fx2N-64MR which is installed in Bow Thruster, so i planned just copy its EEPROM information and put to Fx3U-64M's EEPROM. Is it possible ?
I'm confused because of
EEPROM modules for FX2N-64MR and FX3U-64M are not same, anyway is it possible to copy working algorithm from one to another ?
http://6g6.eu/sih-memorycable is EEPROM for FX3U-64M
http://6g6.eu/sih-bow-thrustereeprom is EEPROM for
FX2N-64MR
I got a USB cable an adaptor, but not sure if it fit http://6g6.eu/sih-cableadapter
I'm in doubt because have already contacted one guy from Mitsubishi tech support and he replied i need "SC09N programing cable", but what for is mine "Mitsubishi FX-USB-AW" ?
This is a system general arrangement for Bow Thruster
http://6g6.eu/sih-bow-thuster-arrangement
and for Stern Thruster are completely the same.
The situation is as followed:
I'm working at ship and it has Bow Thruster and Stern Thruster and these thrusters have above mentioned PLCs. Once old one PLC Fx2N-64MR was damaged by salt water and it was on Bow Thruster.
Without a spare PLC i just removed working PLC from Stern Thruster and installed it to Bow Thruster.
Then my company sent a new PLC as they said new model- Fx3U-64, and I have installed it to Stern Thruster, but the problem is - I don't have a logic algorithm for Fx3U-64, EEPROM is new and without any logic, so i need to program it. But working logic still exists in old module Fx2N-64MR which is installed in Bow Thruster, so i planned just copy its EEPROM information and put to Fx3U-64M's EEPROM. Is it possible ?
I'm confused because of
EEPROM modules for FX2N-64MR and FX3U-64M are not same, anyway is it possible to copy working algorithm from one to another ?
http://6g6.eu/sih-memorycable is EEPROM for FX3U-64M
http://6g6.eu/sih-bow-thrustereeprom is EEPROM for
FX2N-64MR
I got a USB cable an adaptor, but not sure if it fit http://6g6.eu/sih-cableadapter
I'm in doubt because have already contacted one guy from Mitsubishi tech support and he replied i need "SC09N programing cable", but what for is mine "Mitsubishi FX-USB-AW" ?
This is a system general arrangement for Bow Thruster
http://6g6.eu/sih-bow-thuster-arrangement
and for Stern Thruster are completely the same.
Last edited: