Horner HE-XT104 usb question

iNickster

Member
Join Date
Jan 2018
Location
SC
Posts
8
I have a Horner HE-XT104 PLC. Can I use a standard USB mini-B cord to update the firmware on the PLC through cScape?
 

Similar Topics

I am having a problem communicating my PLC with Drive via Modbus connection. I start by opening the port and there is no problem, but then when I...
Replies
5
Views
56
Hello, I’m new to this forum and if I’m posting incorrectly let me know. I’ve been having an issue I can’t seem to figure out. I’m sure it’s...
Replies
1
Views
102
I seem to be making this harder than it should be, and Its not making any sense. I simply need to move a real variable to two integer variables...
Replies
8
Views
903
I am using Cscape 9.9 service pack 8. I am writing my program as a variable based program not register based. When I try and have the output...
Replies
1
Views
797
I have a Horner PLC that is reading Ascii string from a device. When the device responds, it responds with the hex value in Ascii. I need to...
Replies
8
Views
2,323
Back
Top Bottom