View Single Post
Old February 22nd, 2007, 12:08 PM   #10
Julian
Member
Argentina

Julian is offline
 
Join Date: Feb 2007
Location: Baires
Posts: 1
Creonics

We are working with a system that uses an Allen Bradley servo controller model MAX CONTROL and an SLC 500 plc. The controller doesn’t seem to be working properly and we are going to replace it.

The problem is that we have very little information about this module, and couldn’t find anything on the internet, since it is obsolete.

There are 3 status leds on the front panel of the controller, and the first 2 of them always remain on. We know this is a fault code, but we don´t know what it means.
  Reply With Quote