Does anyone have experience with a sensaphone scada 3000?
I have an application where a customer is using the 3000 as their pump station Alarm system and PLC. I have never seen one of these, nor did I know SensaPhone had something that could handle control.
Anyway, the customer wants to extract data from the unit via their plant SCADA system.
The customer has the programming software on a laptop for the unit. I didn't put my hands on it yet.
After looking at the manual, it looks like there are a few RS232 plugs on the unit, and the manual also references Modbus. First theory is to connect to the 3000 via serial and poll the modbus addresses. First problem, the manual does not do a good job explaining how to utilize Modbus. Maybe its like a SCADApack where everything object is a Modbus Register???
Any help or words of advice?
I have an application where a customer is using the 3000 as their pump station Alarm system and PLC. I have never seen one of these, nor did I know SensaPhone had something that could handle control.
Anyway, the customer wants to extract data from the unit via their plant SCADA system.
The customer has the programming software on a laptop for the unit. I didn't put my hands on it yet.
After looking at the manual, it looks like there are a few RS232 plugs on the unit, and the manual also references Modbus. First theory is to connect to the 3000 via serial and poll the modbus addresses. First problem, the manual does not do a good job explaining how to utilize Modbus. Maybe its like a SCADApack where everything object is a Modbus Register???
Any help or words of advice?