Self Powered Remote Sensor

Geoff White said:
The sight lines are a tube running up the side of the tank. The sensor would only need to be clipped to tube at arms reach from the bottom of the tank.

It's not a stupid idea, just half arsed.
Click to expand...
Didn't mean it's impossible or even hard. More that the time it takes costs money and add up a few years..
 

Similar Topics

S
Connecting self-powered analog signal to Moore PLC
I am using Moore APACS/Quadlog PLC. The analog cards are Moore SAM (Standard Analog Module). The SAM accepts 4-20 mA DC two-wire transmitter...
Replies
2
Views
10,030
Tom Jenkins
Tom Jenkins
K
PLC going into program mode by itself
Hello friends I think this is the second post about this all over the internet, first one was in 2013 by some guy from Canada who experienced the...
2
Replies
26
Views
6,386
I_Automation
I_Automation
A
AB Compact Logic 1769 L32E "YEAR" changes byself
Hello; We have an Allen Bradley compact logic processor at an auto glue kitchen of corrugator machine which connected with AB HMI. Normally to...
Replies
5
Views
2,423
plvlce
P
PLCstarter1884
Obtaining Beckhoff Network Hardware for Self Training
Hello Friends, I'm starting a new job soon, towards the end of September, that will be using all Beckhoff equipment. I have programming...
Replies
4
Views
1,056
LadderLogic
LadderLogic
M
1756-L55 Processor putting itself to Remote Test mode?
Hi all, Any experience of the above? Happened 3 times now in 1.5 months. Processor is about 10 years old, software major revision is 19...
Replies
9
Views
5,539
I_Automation
I_Automation
Back
Top Bottom