RX3i Invalid Sweep Mode error??

NetNathan

Lifetime Supporting Member
N
Join Date
Nov 2011
Location
Corona, CA
Posts
2,199
I am starting a new plc.
Download okay no faults.
But on CPU Start I get:
Error 8533: Unable to start runtime. Controller Error - Invalid sweep mode [0x05][0xF6] [0x803D0022]

What causes this error??
 

Similar Topics

I
Addressing in Rx3i PLC
I have a system using Rx3I CRU320 redundant CPU with Proficy Machine Edition Software. In the hardware configuration of each CPU module, under...
Replies
14
Views
356
IAR86
I
M
PACS Rx3i CRU320 - variables missing between redundant controllers
Hi, we are using Rx3i CRU320 redundant PLC system and we noticed a discrepancy between Primary and Secondary controller. Couple of variables (DI)...
Replies
8
Views
259
mastops
M
S
Simulate/Force Analog Inputs with Emerson RX3i PACSystems?
Hi there, I'm doing some extensive testing and commissioning with a slew of new Emerson PACSystems RX3i PLCs. It would be convenient to...
Replies
5
Views
93
Steve Bailey
Steve Bailey
moistcat
Emerson/GE RX3i RS485 2 wire
Hi there, Trying to get some ascii serial communications working via RS485 (COMMREQ functions). I have attached our wiring for the COM2...
Replies
1
Views
962
moistcat
moistcat
M
Emerson PAC/RX3i CPE305 Controller - Troubleshooting/Viewing Eth. Ref. Address
Hello all, First time poster, long time viewer of these forums. Could not find my solution on here. We have had issues with a Comm Fail on an...
Replies
2
Views
359
MichaelIEC
M
Back
Top Bottom