Powerflex 527 drive setup in IO

ziyaddin2015

Lifetime Supporting Member
Join Date
Nov 2019
Location
USA
Posts
84
I am trying to setup the new powerflex 527 to use for training purposes but it wouldn’t let me to finish adding it to an IO and I would get an error saying time sync which I made sure was enabled. I don’t why it would still said it’s an issue? Also, can I just add drive to an IO tree in studio without a motor? I am using 1756-L72 controller, en3tr and studio 5000 version 33. Thanks

63BDF91C-7A8B-4B15-9A6F-38BAD9A9DCF6.jpg 1797FE0B-8F06-48D4-83F9-2DA3A17BB11A.jpg 0B0332D5-64CA-468C-8D78-E4B69789A087.jpg
 

Similar Topics

I swapped out a PF 527 drive that has been giving me occasional faults. I replaced with a new 527, assigned its IP and gateway and cycled power...
Replies
3
Views
1,960
Hi, I am having an application in which we are having a Roller rotating via Powerflex 527 drive. The operator can change the speed of this roller...
Replies
11
Views
4,456
We plan on having a stationary panel with a PLC , 3 Powerflex 527 drives , with the incremental encoder from the motor to the encoder option card...
Replies
4
Views
3,430
Hi all, I am having issues with a Powerflex 527 STO. I am hard wiring a safety relay (guard master MSR27TP) to S1 and S2 and also the common to...
Replies
5
Views
1,629
I've got motor that ran fine for years, but now it's sarting to overshoot its target position a few times a day. Is this indicative of a motor...
Replies
24
Views
5,685
Back
Top Bottom