Alarm banner on Panelview Plus 1500

GeryUm

Guest
G
Hi..
I used Panelview Plus 1500 communicate with PLC-5/25 via DH+. I have setup alarm banner and only display if we reset Panelview or boot to Panelview. In normal operation, if alarm triggered, alarm page is still empty.
I use bit triggered type for 64 alarms (starting from bit b3:0 to b3:3).
How to solve this problem?
Thank you for help.
Gery
 

Similar Topics

This is an issue that I noticed we have had recently on this keypad HMI, an alarm will come up and it can be acknowledged by a fault reset button...
Replies
0
Views
537
The banner is completely unreadable. Is there a way to adjust the size that the alarm banner will display on FT ME 7.0 for application? Thanks...
Replies
1
Views
2,360
I am using a Panelview 2711-B6C8 PV600 with an alarm banner, the banner does not pop up when I get an alarm but the alarm shows up in the alarm...
Replies
4
Views
3,408
Well, hello all, this is my first post. I really need some help with this one. I have a SLC 5/05 processor and I will be connecting to a PV Plus...
Replies
2
Views
2,943
Hi everybody!!! I have a problem with a PanelView 300 Micro. I have introduced the screen "Alarm Banner" and I have created the list of trigger...
Replies
2
Views
3,068
Back
Top Bottom