Directlogic250 problem

Buggzy

Member
Join Date
Nov 2017
Location
Victoria
Posts
1
Hey guys, i have a second hand 250 CPU i'm trying to connect to on my test bench and i cant for the life of me get it to connect.

plc is on with power light green
switch is on term mode
cable is from the automation direct box of cables - port 1 - rj12 lead plugged into a d type serial plug into com1 on pc
serial port is set to com 1
baud rate 9600 - odd
only setting im not sure is the address - i have it on the standard "1"

using directsoft 6 - just keeps saying cant detect plc.
I have tried K sequence and direct net

is there anything i have missed or is maybe the CPU cactus?
 

Similar Topics

Hi We're having issues with an FX1N-1DA-BD Analog output module. We're using an metallic contamination sensor MCS 1000 to detect particles. This...
Replies
1
Views
60
Hi everyone, I'm trying to simulate any program in control expert and see a register in Modscan32 or any software to do that (Like ModbusPoll). I...
Replies
0
Views
61
Hi all. I´ve got a little problem with my FT View SE alarm window. On my PLC program, I have 200 SINT for alarms, in which every bit is for one...
Replies
2
Views
134
Hi all, Im stuck trying to support a client with Motorola ACE.. I was able to upload all of the other sites to STS but one. Im working remotely...
Replies
0
Views
77
Hello I am writing to request assistance with obtaining a specific GSD file for our Mitsubishi inverter type A800-E, which is connected to our...
Replies
10
Views
225
Back
Top Bottom