View Single Post
Unread July 11th, 2019, 07:59 AM   #3
Mihal33
Member
Slovakia

Mihal33 is offline
 
Join Date: Jun 2019
Location: Kosice
Posts: 2
Hello Ken,


thank you for the quick response, I managed to get it work (Conf. assembly 20/70 or 21/71), but not with the communication configuration i wanted, first i used conf. Assembly (100/101) witch should required 8 bytes in and out, but there was the error 89. The auto idetification wasnt working correctly for this solution, because it automaticly was setting in and out parameter to 4 bytes witch is for the other two assembles. I ll try it later when i finish other project.

The EDS I used is from this page Schneider in EDS files v1.8
  Reply With Quote