Kinetix 300 Servo Drives

lostcontrol

Lifetime Supporting Member
L
Join Date
May 2009
Location
NeverSayNever
Posts
1,069
Hi,
We are starting to use these drives, but I a bit disappointed with the IO connection options.
Apparently, the only 'approved' connector available is the ugly terminal block ' 2097-TB1'.
Looking at the spec's on the connector, it is a '50-pin SCSI'.

Surely, I should be able to locate this type of plug & make my own..?


What do y'all do?
 

Similar Topics

N
Kinetix 300 Servo communication with Python
Hi! I'm trying to communicate with an old Kinetix 300 drive that is fully functioning. Is there any library I can use to monitor this drive with...
Replies
0
Views
425
nuwan
N
N
Kinetix 300 Servo communication with Python
Hi! I'm trying to communicate with an old Kinetix 300 drive that is fully functioning. Is there any library I can use to monitor this drive with...
Replies
0
Views
479
nuwan
N
A
Help with basic setup of Kinetix 300 & TL Servo Motor
Currently tinkering with a home project for a wood router lift machine using some second hand parts from a redundant timber mill. The servo is a...
Replies
3
Views
2,426
atomic10
A
O
Kinetix 300 in velocity mode (Servo.Out.ReferenceSource = 1) and drive not run
Hello, I am using Kinetix 300 with CompactLogix (Ethernet IP) and it works well, but happened twice along one day the following situation: I...
Replies
0
Views
1,973
ortega
O
B
Kinetix 5300 MSO causing ExcessiveVelocityErrorFault
Have a system that has been running for over a year and all of a sudden getting a ExcessiveVelocityFault on one of the drives when the MSO command...
Replies
2
Views
142
padees
P
Back
Top Bottom