Connected Components Workbench Analog Output Programming

Join Date
Dec 2017
Location
Seattle
Posts
4
Hi all,

I'm having trouble programming the analog output on my Allen Bradley Micro850 with OF4 extension. I enabled the channels, minimum-maximum output range 4-20mA, with the data format in engineering units. I'm trying to control an inverter wired to a motor. I used the MOV instruction block to assign my analog output with values from my analog inputs, but it seems that the analog output does not produce any signals (tried with my multimeter) even though there are values in CCW's live mode. Does anyone have the solution for this?

Thanks,

-Grant
 

Similar Topics

was trying to use Connected Components to connect to a 525 drive via usb with the face off but can't seem to connect to it. the screen lights up...
Replies
7
Views
683
So I'm using CCW to program a panel view and this is not my first I have done many. My Problem is I get an error message that I have never seen...
Replies
2
Views
462
How do you expand a branch in connected components workbench. Example i want to add an interlock around more than one contact. Most software you...
Replies
14
Views
1,218
I’m working on a conveyor project for work. We’re trying to install a few diverts to carry product directly to one of two trailer doors. I have...
Replies
5
Views
1,004
I cannot get CCW to add a controller, i keep getting a error message saying that the device is not authorized. This happens with any model and...
Replies
1
Views
1,267
Back
Top Bottom