rexroth hacd dpq issue

dougpdf

Member

D

Join Date

Feb 2014

Location

kentucky

Posts

48

• Jul 13, 2019

• #1

Hi all
I have a Rexroth HACD DPQ module and loaded up the Bodac software. I can't get the configure page to open.
Anyone have any experience?
Thanks
Doug

 

dougpdf

Member

OP

D

Join Date

Feb 2014

Location

kentucky

Posts

48

• Jul 14, 2019

• #2

It's like it's in demo mode and don't have access to all the screens.
I can connect though
argh

 

ndzied1

Lifetime Supporting Member

Join Date

Aug 2002

Location

Chicago, Illinois

Posts

2,855

• Jul 14, 2019

• #3

There do appear to be password levels in the card but I don't know what the default passwords are. Have you tried calling Rexroth?

Do you have the manuals? It doesn't say for sure but the level 1 password might be 1
and the level 2 password might be 2? The manual is not clear on this.

 

dougpdf

Member

OP

D

Join Date

Feb 2014

Location

kentucky

Posts

48

• Jul 14, 2019

• #4

Oh my....Norm, you're my hero.
it was 2. I've been messing with this since yesterday morning and poof, there are the rest of the tools.
Thank you sooooooooooooooooooo much !
Doug

 

dougpdf

Member

OP

D

Join Date

Feb 2014

Location

kentucky

Posts

48

• Jul 15, 2019

• #5

I've got it working in "analog" mode
I'd like to use it in "internal" mode.
Do you know if it's possible to get an HMI to connect to it for adjusting set points, etc ?
Thanks

 

ndzied1

Lifetime Supporting Member

Join Date

Aug 2002

Location

Chicago, Illinois

Posts

2,855

• Jul 17, 2019

• #6

dougpdf said:

I've got it working in "analog" mode
I'd like to use it in "internal" mode.
Do you know if it's possible to get an HMI to connect to it for adjusting set points, etc ?
Thanks

Click to expand...

It depends on whether or not the card has some form of communications on it. I believe there were versions with CAN, DeviceNET and ProfiBus. Check the p/n on the card against the data sheet.