View Single Post
Old July 13th, 2005, 11:26 AM   #8
Mr_B
Member
South Africa

Mr_B is offline
 
Join Date: May 2005
Posts: 79
The Load will never break. The material flow is to the right. At the moment drive a works with a "speed" pot and b also with the same "speed"pot but also through a "ratio"pot.

So the "speed"pot adjusts both the drives'but the "ratio" only drive "a".

So the Operator sets the "ratio"pot to get tension between the 2 motors. This tension is not measured at the moment.

I wanna know if I can do this automatic. This tension. Hope u understand better now.
  Reply With Quote