kinetix 300 "start homing on enable"

I have been using an AB Ultra 3000 servo drive to control a servo motor and it was setup to "home on enable". I have had to change to a Kinetix 300 drive and it seems like there is no way to have it carry out the same home function when it is turned on. Can anyone help me please.

Is the enable signal an input?
Maybe you could link the enable input to another input, & configure that for homing.

Thanks for your input. Seems that the Kinetix 300 has a permanent memory of where home is once it is set. Not so clear in the notes. Spent all day sorting this and some other issues. Looks like I am rolling. Thanks again.
Oystek