View Single Post
Old May 24th, 2018, 03:04 PM   #1
United States

Pete_S is offline
Join Date: Mar 2015
Location: Portland Maine
Posts: 70
Studio 5000 Message Communication Path


I am trying to configure a CIP data table read MSG instruction to read a tag on a L85E controller and write to a L82E controller. The L85 routing is,1,0 and the L82E is,1,0. I am struggling with the path. My understanding from the programming manual is that my path in the Communication tab would be 1,0,,1,0. However when I try to enter this I get an error "Use of period of alphabetics is restricted to IP addresses, which cannot appear as the first field of a path. My IP address isn't the first field in my path, so I am confused. Any help would be greatly appreciated. Thanks!
  Reply With Quote