Hello men
Hardware:
PV Plus 1000
1769-L32E Proccessor
1769 I/O
Stratix Unmannaged Switch
I am trying to upload a project named "test_1" to my PanelView. I have never configured a PV before so I have a question.
First of all this is what I have done.
I have assigned the PV an IP and the first 3 octets are the same as the proccessor.
I see the PV IP address in RSwho and also in RSLinx Enterprise. So I assume all is well.
On the PanelView: But when I go to "Networks and Communications", "RSLinx Enterprise Communications", I get this...
[-] Virtual Backplane
<No Devices
[-] Ethernet
<No Devices
[-] Serial-DF1
<No Devices
Of course I should see my communcations path under "Ethernet" but nothing shows up.
When I open FT View ME on my PC, it shows the communications path on my PC but not on the PanelView itself.
I assume this is why I am unable to upload my project called "test_1"
Any thoughts or suggestions to help me troubleshoot this problem successfully is very much appreciated!
Thanks
Kandy
Hardware:
PV Plus 1000
1769-L32E Proccessor
1769 I/O
Stratix Unmannaged Switch
I am trying to upload a project named "test_1" to my PanelView. I have never configured a PV before so I have a question.
First of all this is what I have done.
I have assigned the PV an IP and the first 3 octets are the same as the proccessor.
I see the PV IP address in RSwho and also in RSLinx Enterprise. So I assume all is well.
On the PanelView: But when I go to "Networks and Communications", "RSLinx Enterprise Communications", I get this...
[-] Virtual Backplane
<No Devices
[-] Ethernet
<No Devices
[-] Serial-DF1
<No Devices
Of course I should see my communcations path under "Ethernet" but nothing shows up.
When I open FT View ME on my PC, it shows the communications path on my PC but not on the PanelView itself.
I assume this is why I am unable to upload my project called "test_1"
Any thoughts or suggestions to help me troubleshoot this problem successfully is very much appreciated!
Thanks
Kandy