|
Mitsubishi Q-series: adding a new Analogue Input card
Hi, I've run out of analogue input channels on my Q68AD-G module.
If I add a new Q68AD-G module and install it into a spare (blanked-off) slot, it will need to be configured of course.
I will need to update the "I/O Assignment" section, but not sure about the "Base setting" section (not even sure what that section is for, to be honest. I will also need to "enable" the new card for reading using the Un\Gx commands in the ANALOGUE ladder logic.
Is there anything else I need to do to configure the card? Thanks
Last edited by Mas01; January 13th, 2021 at 10:48 AM.
|