I have a 2711R-T4T that I am hooking up to a MicroLogix 1400 to replace a PanelView Micro 300. There is a tag I am trying to configure in Connected Components Workbench for the HMI. In the old PanelView, the tag is configured as follows:
Tag Name: Yield
Data Type: Signed Integer/Int
Address: N17:110
Scale: 0.001
Min: 0
Max: 32
In the tag editor for CCW, the tag is configured as follows:
Tag Name: Yield
Data Type: 16 Bit Integer
Address: N17:110
Data Entry – Min: 0
Data Entry – Max: 32
Scaling: ✓
Raw – Min: 0
Raw – Max: 32
Scaled – Min: 0
Scaled – Max: 32000
It appears that the numeric entry works correctly but I have the same tag (Yield) used as the Indicator Tag and the value that is displayed is not the same as what is displayed on the original PanelView. It appears to be rounding the value up to the nearest whole number. I have the Numeric Entry formatted as follows:
Decimal Point: Fixed Position
Group Separator: Use Language Preference
Keypad Type: Numeric
Maximum Value: 999
Minimum Value: 0
Negative Number Formats: In Front
Number of Decimal Places: 3
Numeric Field Width: 5
Is there a way I can get this indicator to read as it did on the old PanelView? For example, read 1.234 instead of 1?
Tag Name: Yield
Data Type: Signed Integer/Int
Address: N17:110
Scale: 0.001
Min: 0
Max: 32
In the tag editor for CCW, the tag is configured as follows:
Tag Name: Yield
Data Type: 16 Bit Integer
Address: N17:110
Data Entry – Min: 0
Data Entry – Max: 32
Scaling: ✓
Raw – Min: 0
Raw – Max: 32
Scaled – Min: 0
Scaled – Max: 32000
It appears that the numeric entry works correctly but I have the same tag (Yield) used as the Indicator Tag and the value that is displayed is not the same as what is displayed on the original PanelView. It appears to be rounding the value up to the nearest whole number. I have the Numeric Entry formatted as follows:
Decimal Point: Fixed Position
Group Separator: Use Language Preference
Keypad Type: Numeric
Maximum Value: 999
Minimum Value: 0
Negative Number Formats: In Front
Number of Decimal Places: 3
Numeric Field Width: 5
Is there a way I can get this indicator to read as it did on the old PanelView? For example, read 1.234 instead of 1?