Lots of input here. Thanks everyone!
The flow meter does not have any output pulse that can be utilized. The system is all built, and I don't wish to add a periodic task, but I may have to. Noise over wires could be a problem. I'll build what I can and I'll see what it does.
Also, this is a quench, so I'm only looking at the signal for about 10 seconds. The first second of that is crazy noisy because the water shifts from a bypass valve into the tool, and it takes a bit to settle down. It sounds to me like the current meters and mechanical setup may not be well fitted for totaling.
Again, Thanks!
|