DeltaV PK controller

Chris Hasler

Member
Join Date
Jul 2015
Location
England
Posts
92
Has anyone used a DeltaV PK controller, in standalone configuration?

It is not working out too well for me:
  • It does not retain any IP addresses once the controller is powered off
  • I cant swap projects
  • Wiping the laptop and reinstalling didn't fix it

Is this a case of I am stupid or its actually FUBAR?

Does anyone have any ideas other than going to the pub?
 
I have never used any DeltaV gear, however I have found that going to the pub and letting things sit overnight often helps you take a new look at it from a different angle in the morning.

Good luck.

Hopefully someone else here has actual technical words of wisdom!
 
The pub is helpful. Not listing to the guy saying to would be nice to use the just released contoller would have been better...

Its the port settings on the PK controller. Now to wait for Emerson to fix the firmware.
 

Similar Topics

The site I am working with has a site-wide DeltaV SCADA system. I am working on a package that all falls under a single ControlLogix controller...
Replies
1
Views
1,813
gents, I am trying to configure communication with EMERSON PK300 controller through port A1 using generic ethernet communication module . I could...
Replies
0
Views
24
Hello, Does anyone know how to export the EDD files for a device in DeltaV Explorer 12.3? I can export the .fhx, but I have no idea how to get...
Replies
5
Views
79
Hi experts hope you are well. Would any one be able to tell if it is possible to pull data from a Delta V DCS and display it on a TP700 comfort...
Replies
0
Views
434
I have a DeltaV system that I am using to control some powerflex 755 drives over Ethernet/IP. I don't have any experience with DeltaV or any way...
Replies
0
Views
758
Back
Top Bottom