lostcontrol
Lifetime Supporting Member
Hi,
Have seen a couple of occurrences of this error during search:
failed to go online with controller.
Unable to open connection -- all connections may be in use
From knowledgebase, it mentions that the 100% utilization is related to continuous task config.
If I change the task to periodic, will that assist in alleviating this issue.?
I am aware that the ethernet CPU is very loaded often & have plans in place to rectify, but interim is we need to keep it going.
Is there a way to reset port remotely, so at least IO Servers can reconnect succesfully & perhaps RS5k..?
Thanks
lc
Have seen a couple of occurrences of this error during search:
failed to go online with controller.
Unable to open connection -- all connections may be in use
From knowledgebase, it mentions that the 100% utilization is related to continuous task config.
If I change the task to periodic, will that assist in alleviating this issue.?
I am aware that the ethernet CPU is very loaded often & have plans in place to rectify, but interim is we need to keep it going.
Is there a way to reset port remotely, so at least IO Servers can reconnect succesfully & perhaps RS5k..?
Thanks
lc